2Drag the start and end handles on the waveform or the timeline, or type exact timecodes if you already know them.
3Preview the selection and run the cut — the part you keep is copied through untouched wherever the format allows it.
4Download the trimmed Video file.
Trim Video FAQ
How does Video Cutter cut the file?
+
Concretely, the cut is stream-copied at a keyframe boundary wherever possible, so most clips trim in seconds regardless of how long the source was. You set the start and end points on the waveform or the timeline and keep what is between them.
How precisely can I place the start and end points?
+
You can type exact timecodes rather than only dragging, and the preview scrubs to the position as you move it. How exact the result can be depends on the format: some allow a cut anywhere, others snap to the nearest frame or keyframe.
Does the format limit where I can cut?
+
It does. this format is read and written by the same streaming pipeline as everything else we support. That is precisely what decides whether a cut can be placed arbitrarily or has to land on a structural boundary.
Anything specific to Video when trimming?
+
Yes — the container and codec are probed before anything runs, so mixed uploads in one batch are handled per file. It explains most of the "the cut is a fraction of a second off" surprises.
Can I remove a section from the middle instead of keeping one?
+
Yes — cut the piece before it and the piece after it, then merge the two results. That is deliberately two steps because it keeps both halves on the fast, lossless path instead of forcing a full re-encode.
Is the part I keep re-encoded?
+
Not if the format allows a stream copy — the data you keep is bit-identical to the source and the job finishes in about the time the upload took. Only a frame-exact cut on a format that cannot do it cheaply needs a re-encode.
Which video formats does Video Cutter accept?
+
MP4, MOV, MKV, WebM, AVI, WMV, FLV, 3GP, M4V, MPEG and MPG. Each file is probed for its real container and codec before anything runs, so a mixed batch is handled correctly file by file.
Is there a file size limit on Video Cutter?
+
Yes: free accounts process video up to 1 GiB per file whichever container you brought; ffmpeg with x264, x265 and libvpx does the encoding. It is high enough that upload speed is usually the binding constraint rather than the cap itself.
Will Video Cutter lower the quality of my videos?
+
Only if the operation requires re-drawing frames. Container-level and timeline-level work is done as a stream copy, which is bit-identical to the source and finishes in seconds. Anything that must re-encode does so at a quality level you choose.
Can I run Video Cutter on several videos at once?
+
Yes, and it matters here more than anywhere else — video jobs run in minutes, so queueing the batch in parallel is the difference between one wait and several.
What happens to audio, subtitle and chapter tracks?
+
They are carried across wherever the target container can hold them, including multiple audio languages, embedded subtitles and chapter markers, rather than silently keeping only the first track of each.
Does Video Cutter cost anything?
+
No. Video Cutter is free without an account, and the output has no watermark, corner logo or intro card. Uploaded video is deleted from the workers shortly after the job completes.
Et ass eng vun deene gréisste Free-to-Play-Spiller. 00:00:00
Datei ze grouss
Dir probéiert Dateien ze konvertéieren, déi méi grouss wéi 1 GB sinn. Kaaft Kreditter, fir datt Dir méi grouss Dateien bis zu 100 GB konvertéiere kënnt.
